Is it possible to have "oct note", "2 oct note", "3 oct note", etc.?

Questions and Support
#1

Beginner here, I’m currently learning by porting synth patches from other synths and building them back up layer by layer.

image
image730×376 19 KB

We currently have note and oct note. It’d be handy if we could determine the scale itself. When I now look at my remap of note, it’s only constricted to the 1.5 octaves it’s playing. That’s too small to do proper remapping as I want this

image
image1758×720 52.9 KB

but as you can see, the range of it is only now used in the middle of the remap but I want to use the whole range.

Oct note is too small.

Note is too big.

How do I adjust the “remap window range” ?

#2

You can lock the oscs into any scale by selecting notes - just under the pitch word on the osc
Now whatever Oct it’s in will be in scale.

You can change the grid of the remap (or any lfo) to be in 12 steps so you can lock notes into it, as long as the modulation amount is set to an Oct amount (12, 24, 36 etc)

Otherwise your DAW also likely has a midi controller you can put before the instrument to lock in i to a scale

Hope this helps but not sure if it answers your question!

#3

Increase the amount of modulation or create a very steep slope in the remap